In my efforts to freshen up the motor on my new sports six, I removed
all external components. I taped some plastic around the head covering
the Valve assembly. I then began to sand blast the block preparing it
for paint. After painting the block I removed the taped plastic. I had
not considered that some of the sand had adhered to the tape and a few
grains fell on/into the head. I vacuumed up the few grains but I can not
be certain that any fell into the push-rod tubes.
Any suggestion, I would like to keep from removing the head if at all
possible. But if I must I must..
ronnie babbitt
/// triumphs@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|