I spent some time monkeying around with the bypass valves on my ZS carbs
yesterday. I have been having problems with RPM falling below idle than rising
back to idle as I come to a stop. I noticed a note in Jay Welch's technical
reference (Thanks very much for this Jay). Adjusting the valves pretty much
eliminated this nagging problem. Others have told me that's just how they
are.
I also took a look at the breather setup which had been causing uneven idle
problems until I capped the fittings on the carbs. I do not have the adaptors
from the carb fitting to the rubber emission hoses. I am guessing that these
have calibrated orifices and without them I may be breathing too much when
vacuum is high. Moss shows them as N/A. Does anybody have a couple of these in
their parts box they'd be willing to sell me? If not, could somebody get
dimensions? OD, ID, orifice size?
Thanks,
Hugh Fader
72 TR6
/// triumphs@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|