John,
I had the same thing happen to me. In my case the MC's bore was pitted
and
would not seal. I tried honing it out but in the end I ended up replacing
the MC.
Roger
'71 TR 6
-----Original Message-----
From: owner-triumphs@autox.team.net
[mailto:owner-triumphs@autox.team.net]On Behalf Of John Summers
Sent: Wednesday, September 11, 2002 3:04 PM
To: triumphs@autox.team.net
Subject: Clutching
Folks, about three weeks ago my clutch pedal sort of went to the floor.
Getting into gear was next to impossible. This is the same condition I
encountered the first day I got the car in October '98.
Today (duh!) I thought to check the fluid level in the clutch master
cylinder and (duh!!) it was nearly empty.
I refilled it and pumped the clutch a few times and without driving it yet,
it seems ok..
The failure three weeks ago seemed to come on suddenly; I.E., within two
shifting cycles and five miles from home. I have read the clutch MC/SC
section on the Buckeye Triumph web site thinking about and "looking forward"
to rebuilding both.
My question is: If this happens again, soon, is it rebuild time? The
remaining fluid in the cylinder was "dark" and it seems I remember from the
article that that is a sign that the rubber parts inside the cylinder are
deteriorating.
I'll drive later and see how it holds up.
Opinions?
John Summers
'74 TR 6
/// triumphs@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|