Burn the heck out of the rubber bushing using either a propane torch or
Oxyacetylene setup. Carefully use a reciprocating saw or angle grinder
with 1/8" disk to cut the bolt in half ; extract Bracket! Buy new bolt :-)
Steve
At 08:08 PM 20/08/2002 -0400, you wrote:
>http://homepage.mac.com/andrer/2002/08-20/images/DCP01438.jpg
>
>Ok I can only assume a little heat will solve this problem?
>
>I can't get the bolt move at all. I did manage got one, but the rest would
>not respond to my air hammer.
>
>A.
>--
>Andre Rousseau - Ottawa Canada
>1968 Triumph GT6 MK I
>http://www.justdrive.ca/
/// triumphs@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|
