>then use a drill bit (preferably in a drill press) slightly smaller
>than the minor diameter of the bleed screw to drill through the center of
>the screw.
Use a LEFT-HANDED drill. You can buy them at serious tool stores. The regular
right-handed twist drill will tighten the fitting as you drill. The vibration
and torque of a left-handed drill (obviously, your drill-press needs to be
reversible!)
will often remove the part. At least it won't make matters worse...
Phil Ethier
/// triumphs@autox.team.net mailing list
/// To unsubscribe send a plain text message to majordomo@autox.team.net
/// with nothing in it but
///
/// unsubscribe triumphs
///
/// or try http://www.team.net/cgi-bin/majorcool
|