Sorry Dave, I sent this to you instead of the list...
"Power British Performance Parts, Inc." wrote:
> David Massey wrote:
>
> > Message text written by Sandy Levine
> > >thought I would try this again as I had no previous reply. can anyone help
> > with the exact location of the Triumph badge that goes on the rear valance
> > above the right tail lamp assembly for a 70 TR6
> > thanks
> >
> > <
> >
> > Sandy,
> >
> > My car has two plastic retainers in the rear valance to recieve this badge.
> > Does you car not have these? If not (due to some body repair work???)
> > then I will have to check my car which is at home at the moment while I am
> > here at work.
> >
> > Dave
>
> Sandy,
>
> Sorry I didn't have a chance to measure yesterday (been kinda busy).
> Dimensions for centering the holes are as follows:
>
> Right badge hole - 1 11/16" in from the rightmost edge of the rear valence
> (not the outside of the fender, but the seam between fender and valence. 1
> 3/32" below the top rear edge of the valence where it meets the bootlid.
>
> Left badge hole - 6 27/32" in from the rightmost edge of the valence as
> above. 1 5/32" below the top edge.
>
> Measurements taken from three TR-6 shells currently being restored in my shop.
> All three ('70, '72, '73) have exactly the same dimensions.
>
> Cheers!
>
> Brian Schlorff
> Power British
> http://www.powerbritish.com/~britcars
|