| To: | wizardz@maxinter.net |
|---|---|
| Subject: | How to find the size of a hole |
| From: | "Roger Colson" <sassamon@mediaone.net> |
| Date: | Mon, 15 May 2000 21:06:26 -0400 |
| Cc: | triumphs@autox.team.net |
Paul, An old time machinist taught this one to me. To find the diameter of a small hole try to fit different size drills through it. Use the non-cutting end. When you find a drill that just goes through and the next size up does not. Bingo! I slapped my forehead too. Good luck, Roger Roger Colson 57 TR3 TS21383L sassamon@mediaone.net http://people.ne.mediaone.net/sassamon/TS21383L |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | RE: TR6 ignition lock, AKATR5 |
|---|---|
| Next by Date: | Bikini Top, Adrian Jones |
| Previous by Thread: | Holy Bondo, Batman!, Kai M. Radicke |
| Next by Thread: | Bikini Top, Adrian Jones |
| Indexes: | [Date] [Thread] [Top] [All Lists] |