To: | bstinocher@unipres.com, Triumphs@autox.team.net |
---|---|
Subject: | Re: Gasket remover |
From: | Gbouff1@aol.com |
Date: | Wed, 23 Feb 2000 18:01:56 EST |
I use an old, sharp, 1' wide wood chisel to remove paper and cork gaskets and old gasket sealer from cast iron and steel surfaces (never soft aluminum parts!!). Keep the blade as parallel as possible to the surface when scraping. It works quite well, but be careful when applying pressure as the gasket may give suddenly and cause you to slip. Gary Bouffard 59 TR3A TS58399 |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | RE: 76 tr6 compression, Randall |
---|---|
Next by Date: | Yo Fred !!!, Beth & Ken |
Previous by Thread: | Re: Gasket remover, Geo Hahn |
Next by Thread: | Re: Gasket remover, Joe Curry |
Indexes: | [Date] [Thread] [Top] [All Lists] |