To those of you who advised that all my recent messages looked like a bunch
of question marks, please let me know if you can read this. Thanks to rest
of you for bearing with me.
Jim Wallace
jwallace@canada.hp.com
>
Scott,
> The felt goes away from the bearing i.e. toward the centre of the car. A
> good way to remember this is that you don't want the felt getting into
the bearing.
> For a TR3, and I expect a TR6 would be the same, tighten the castle nut
to five foot-pounds, then back off one hexagon flat.
> Regards,
> Jim Wallace
> ***************************
>
> Happy New Year to all.
>
> I purchased the replacement front hub grease seals > from TRF and wanted
to confirm the proper position > they go on.
>
> The current grease seal is just felt while the
> replacement is felt inside of a metal casing with > the felt exposed on
one side. Does the felt side > face toward the wheel with the metal side
facing
> toward the vertical link or vice versa? (Shane, did > you replace this?).
>
> TIA
>
> Scott Suhring
> Elizabethtown, PA
> '70 TR6
|