I'm in the process of trying to straighten an edge on my front valence. It
had been pushed in about 1" or so and in the process one edge was bent
and it stretched the metal that forms the angle on the underside. I've got
the edge straightened out again but the bottom portion is now buckled up.
I'm under the impression that you can use heat to shrink metal but I'm not
sure just how to do that. I've got an oxy-acetylene outfit but I'm a little
nervous about doing more damage than is already there.
Can anyone help me out on this?
TIA
Brad (Lincoln Nebraska 402-464-1502)
My Web Site Http://www.141.com/triumphs (updated 12/3/98)
1964 Spitfire4 BFC25720L -- 1973 Spitfire 1500 FM3353U
1962 TR4 CT288L -- 1959 TR3A TS41311L
1951 Dodge Truck B-3-B-108
|