Hello,
I have a 72 TR-6 and bought the exhaust system from TRF and the install
hardware kit from Moss. The mufflers hung just find with the brackets
from Moss. My car had two (both look original) brackets on the frame
cross member (one on each side) for muffler installation. Easy and
straight forward. The only problem I had was with the rear pipes that
fit into the muffler. Too long. No amount for moving around or jimmying
would make them fit in at all. I ended up getting them cut to fit
correctly. Everything else, just fine. Oh, they look and sound great!
Joe Burlein
Melbourne, FL
On Thu, 3 Dec 1998 22:01:39 -0500 "Craig & Karen Bentley"
<mmbent@email.msn.com> writes:
>
>Triumphant Listers, A question for any of you that may have had the
>Falcon
>Stainless Steel Twin Sports exhaust system on a TR-6. I've got the
>pretty
>system in my hands and was wondering what you may have done for rear
>hangers. I noticed in the Moss catalogue that its says "The system
>uses the
>standard support ...... only the mufflers need different rear mounts"
>It
>goes on say that these are included in their fitting kit (yeah right).
>TRF
>says "it will be necessary to improvise rear hangers". Now if it were
>up to
>me I'd be getting out the PIG (Plutonium Inert Gas) welder, going down
>to
>the local unobtainium store, and securing a ride on the next space
>shuttle
>to "improvise " my rear hangers. Seriously I'm just looking for some
>suggestions or past experiences that any of you may have had in
>installing
>this particular system. Please bear in mind that what I've got sitting
>out
>in the garage is just a frame with all suspension and running gear
>bolted on
>so I'm not exactly sure what space clearances I'll need as far as
>clearing
>the rear body work is concerned. Any input would be greatly
>appreciated.
>Regards Craig Bentley
>
>
>
>
|