It is so, but it used to be the hole for the grease nipple in the days where
you needed (or could ) grease the pump.
> ----------
> From: Mark Hooper[SMTP:mhooper@pixelsystems.com]
> Reply To: Mark Hooper
> Sent: Wednesday, November 18, 1998 8:30 PM
> To: triumphs@autox.team.net; Tom Rollins
> Subject: Re: TR-6 Question
>
>
> Tom:
>
> That is the weep hole on the pump. When fluid begins to pour from that
> hole
> it is a sure sign that your pump seal is gone
> and thus the pump needs replacement. This is a contrast from the normal
> state of fluids pouring from every other orifice and seal on the car
> which is a sign that you own an LBC.
>
> Mark Hooper
>
> -----Original Message-----
> From: Tom Rollins <tom@ntcs-inc.com>
> To: triumphs@autox.team.net <triumphs@autox.team.net>
> Date: November 18, 1998 3:12 PM
> Subject: TR-6 Question
>
>
> >
> >Greetings!
> >I am new on the list and have a few TR-6 questions. The water pump on my
> '72
> >has a small hole in the casting about where the bearing would be. Is
> this
> >hole for greasing bearing? Does the orientation of the hole matter when
> >installing? Thanks.
> >
> >Tom Rollins
> >NTCS, Inc.
> >tom@ntcs-inc.com
> >
> >
> >
>
|