Well, I was thinking of getting an Ignitor setup for my TR3 (negative
ground), but after reading a number of messages describing "missing", I
think I'll go with the Allison/Crane unit.
Trmgafun@aol.com wrote:
>
> In a message dated 98-09-23 10:16:27 EDT, you write:
>
> << I put one on my '76 TR6. The car started great, but developed a miss
> under load that I could not fix (until I put the points back in). I also
> fitted one to my neighbors '75 TR6. Same result. The 75 & 76 TR6s have
> an internal ballast resistor (in the harness). I never did figure out
> whether or not that was a cause of the miss. I would fit the unit back on
> my car if I could find the cause of the problem.
>
>
> Larry Miceli
> '76 TR6
> '73 Stag
> '66 Herald >>
>
> Larry,
>
> I have the same miss with my newly acquired '76 TR6. It also has electronic
> ignition and the miss is most noticable when taking off from a dead stop.
> Maybe the root of the problem is the same as yours. I'd sure like to get it
> solved.....
>
> Scott Helms
> N. Indiana
--
George Richardson
'57 TR3, TS15559L - painting and reassembling....
http://www.merlingroupinc.com/tr3.htm
|