| To: | "triumphs mail list" <triumphs@Autox.Team.Net>, "shop talk" <shop-talk@Autox.Team.Net> |
|---|---|
| Subject: | cutting masnoite |
| From: | kengano@advant.com (Gano, Ken) |
| Date: | Wed, 29 Jul 1998 22:12:32 -0500charset="iso-8859-1" |
| Importance: | Normal |
I am attempting to "remanufacture" four of the interior panels in the TR3 and purchased a sheet of 1/8" masonite for the base. Every time I try to cut it with the reciprocating saw or the sawzall it either rips or the edge "balls up" and makes a sloppy cut. Does anyone have a good suggestion to make these cuts, particularly the curves. I seem to get a nice cut with a circular saw and a very thin blade, but this will not work on the curves. TIA kengano@advant.com downstate illinois 1959 TR3A TS57756L 1958 Model 10 Sedan TBE9239LDLB |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Summer Party Reservations, Joe Worsley |
|---|---|
| Next by Date: | Luxury of carb rebuild, Dennis Barr |
| Previous by Thread: | Summer Party Reservations, Joe Worsley |
| Next by Thread: | RE: cutting masnoite, Collins, Jack L. MAJ |
| Indexes: | [Date] [Thread] [Top] [All Lists] |