Malcom writes...
>Has anyone bought (or not bought) one of these? Can it do body metal?
>I'm pretty sure it can't be converted to accept bottled gas, and uses only
>flux core wire- but that's OK for me. It did appear to be wire feed tho.
Malcom, the sheet metal on our LBCs is 20 ga <about .036"> Flux core
wire feed welders are at their lower limit here. The MIG setup is a
better choice for body work.
Also, ox-acetylene is making a bit of a comeback for body work. More
initial distortion but better workability of the weld area after the
fact.
Cheers!
Tom O'Malley
'74, '77 Spits
|