triumphs
[Top] [All Lists]

[Fwd: HEEEELP with Problems Starting]

To: triumphs@Autox.Team.Net
Subject: [Fwd: HEEEELP with Problems Starting]
From: "Gav. McNett" <gavin@mcnett.org>
Date: Tue, 03 Feb 1998 18:42:13 -0500
This is a multi-part message in MIME format.
--------------04113A4486987DDDB3153D77
Content-Transfer-Encoding: 7bit



--------------04113A4486987DDDB3153D77
Content-Transfer-Encoding: 7bit
Content-Disposition: inline

Date: Tue, 03 Feb 1998 18:31:04 -0500
From: "Gav. McNett" <gavin@mcnett.org>
To: Tom Wagner - Program Manager <tom.w.wagner@Central.Sun.COM>
Subject: Re: HEEEELP with Problems Starting
References: <libSDtMail.199802021707.10724.wags@housun>
Content-Transfer-Encoding: 7bit

(Really: Try the dry gas)
--GFMcN


Tom Wagner - Program Manager wrote:

> To All;
>
> I wanted to take this opportunity to THANK
> everyone who
> helped me with my problem concerning non-starting
> of my 72 TR 6.
>
> For those who did not see the orginal it is included
> below.
>
> I wanted to tell all of you that the car was finally
> put back together with all the same components that
> it had before and it did start.
>
> Now the task is much easier, as the components will be
> swapped out each one until the bad one is found.
>
> This will make the whole job a lot easier,
> but I wanted to say a BIG THANKS to all of you
> for the help.
>
> Tom Wagner
> 72 TR 6
> 67 MGB
>
> > To All:
> >
> > I know the wisdom the of net here will HEEELLLLLPPPPP
> > me OUT.
> >
> > Problem:
> >
> > I HAD a running 72 TR6 on Sat morning, pulled
> > it out of garage on a nice 50 degree day here
> > in Houston.  Car had been under snow for 6 years
> > needed a new set of points, plugs and condensor.
> >
> > Put them in with the following done:
> >
> >       Regap plugs to .025 in.
> >       Dwell angle of 35 degrees for points
> >
> >       Then checked to make sure that the following is
> >       happening:
> >
> >       Spark on the plugs
> >       Spark at the contact points
> >       Fuel pumping to carbs
> >
> > Car does turnover, but just will NOT START.
> >
> > In the times that I have done the same to my
> > MGB, I have never had this problem.
> >
> > I need help from the whole group.
> >
> > Thanks
> >
> > Tom Wagner
> > 67 MGB
> > 72 TR 6
> >
> >
> >
> >




--------------04113A4486987DDDB3153D77--


<Prev in Thread] Current Thread [Next in Thread>
  • [Fwd: HEEEELP with Problems Starting], Gav. McNett <=