Ken Brown (Kenneth Brown) (Kenneth Brown) (Kenneth Brown) wrote:
>
> Just talked to JC Whitney about getting a sway bar for a 1970 TR6...
> unfortunately they don't stock them anyone. However they did say that if
>enough
> people inquired about them they would reconsider. So give them a call at
> 312-431-9129.
>
> Hoping another vendor doesn't stop carrying TR parts,
> Ken Brown
-------------------------
Ken
I just purchased a rear 3/4" sway bar from J.C. Whitney two or three
weeks ago and I've been fitting it up this past week on my bare 74 TR6
frame. This bar is a genuine Addco ( I called them to verify) and it
only cost 85 bucks plus shipping. The design is similar to the Kastner
setup and I talked to the Brit designer that did it some 20 years ago.
The front 7/8" bar came from British parts Northwest (Check Hemmings).
This bar cost approx. 91 bucks plus shipping and looks good.
TRF, although I do support them buying thousands in parts and going to
their summer party for the last 4 years) is too pricey for their
performance parts (Richard Goode stuff).
Anyways look a little harder in the Whitney catalog and look under car
performance sway bars and you will find a blanket number and place the
order. You should be able to get the rear and if you can't get the front
try B.P.N.W.
Good Luck
Glenn Franco
71 & 74 TR6
|