Re: TR6 - Half Shafts

[Chad Jester <triumph@igc.net>]

Ken Streeter wrote:
> 
> If anybody has actually read this far, I've got a question about this -- when
> removing the hub, two of the six nyloc nuts were more firmly attached to the
> hub mounting stud than the stud was to the trailing arm.  How is one supposed
> to tighten down a stud -- apparently I must be needing to buy another tool!
> Ken,

The appropriate tool, a stud installer, is available from Sears and I'm sure 
Snap-On 
carries one.  If you want, I can probably look up the Sears part number for 
you.  A 
small pair of vise-grip pliers works just as well, and I'm sure you have a set 
of these 
in you tool box ;0

Regards,

Chad