--===============7817886392159588349==
--00000000000040a47505cdb3c997
At the present time I have a Facet pump mounted at the top of the arch
above the axle in my Bugeye. The facet has problems pulling fuel at this
location above the tank. I have an ECCO fuel pump to mount in it's place
and I intend on mounting it on the vertical sheet metal in front of the
tank. Would I have a problem if I just left the Facet pump in place and
cut the new pump in line in the lower location? Would fuel flow freely
through the Facet pump, or should I just remove it?
Mike MacLean
--00000000000040a47505cdb3c997
Content-Transfer-Encoding: quoted-printable
<div dir=3D"auto">At the present time I have a Facet pump mounted at the to=
p of the arch above the axle in my Bugeye.=C2=A0 The facet has problems pul=
ling fuel at this location above the tank.=C2=A0 I have an ECCO fuel pump t=
o mount in it's place and I intend on mounting it on the vertical sheet=
metal in front of the tank.=C2=A0 Would I have a problem if I just left th=
e Facet pump in place and cut the new pump in line in the lower location?=
=C2=A0 Would fuel flow freely through the Facet pump, or should I just remo=
ve it?<div dir=3D"auto">Mike MacLean</div></div>
--00000000000040a47505cdb3c997--
--===============7817886392159588349==
Content-Transfer-Encoding: 7bit
Content-Disposition: inline
------------------------
spridgets@autox.team.net
Archive: http://www.team.net/pipermail/spridgets http://autox.team.net/archive
--===============7817886392159588349==--
|