spridgets
[Top] [All Lists]

Re: [Spridgets] Clutch slave pushrod

To: Jim <jimndi@frontiernet.net> fNDGNi8BqGNPzU4U/U1jLjX3/hfqNcN8SkjQnuIQsTulUehQFgg4Nh2ZDwJSdWaGLpIItf5twNJEzgIOgz4q/gdFBEC+EGPJlWsSX6Vq+8pOKjlcblpyv6C+
Subject: Re: [Spridgets] Clutch slave pushrod
From: Rick Fisk via Spridgets <spridgets@autox.team.net>
Date: Tue, 22 Jun 2021 10:31:52 -0400
Authentication-results: chartermi.net; none a=r1s4udVvJQAa4S1PDOZ50w==:117 a=r1s4udVvJQAa4S1PDOZ50w==:17 a=IkcTkHD0fZMA:10 a=zOoktvdPAAAA:8 a=4ycV2vTZAAAA:8 a=36uSqtSvFww8qLTuLDsA:9 a=QEXdDO2ut3YA:10 a=m3MdUl94G8cA:10 a=psXREZS0v_AA:10 a=GGGinmgZRQXmVEG1E52S:22 a=h1giTkCgq3OATUnuMCPB:22
Cc: spridgets@autox.team.net
Delivered-to: mharc@autox.team.net
Delivered-to: spridgets@autox.team.net
References: <42225056-46ed-6eec-b1c6-b0e69dc7faba@frontiernet.net>
2 11/16" from the hole center to the end for a 1275 pushrod.

Rick

> On Jun 22, 2021, at 10:07 AM, Jim via Spridgets <spridgets@autox.team.net> 
> wrote:
> 
> What is the proper length for a 1275 Ribbed case Trans, slave cylinder 
> push rod?? I have 2 of different lengths?
> 
> Jim Fournier
> 
> Huguenot, NY
> 
> 
> ------------------------
> 
> spridgets@autox.team.net
> 
> Donate: http://www.team.net/donate.html
> Suggested annual donation: $12.75
> 
> Archive: http://www.team.net/pipermail/spridgets  
> http://autox.team.net/archive
> 
> Unsubscribe/Manage: 
> http://autox.team.net/mailman/options/spridgets/refisk@chartermi.net

------------------------

spridgets@autox.team.net

Donate: http://www.team.net/donate.html
Suggested annual donation: $12.75

Archive: http://www.team.net/pipermail/spridgets  http://autox.team.net/archive

Unsubscribe/Manage: 
http://autox.team.net/mailman/options/spridgets/mharc@autox.team.net
<Prev in Thread] Current Thread [Next in Thread>