[Spridgets] No oil flow, no joy

[fogbro1@comcast.net]

List,

After a struggle to shoehorn in a 1275/Datsun Rivergate conversion, I installed 
a new battery and starter and cranked the engine, hoping to see some sign of 
oil flow before installing plugs and actually running the new engine. No joy. 
After a couple of minutes, there was no sign of oil either at the gauge 
connecting point or the pipe going to the filter. I dropped the sump and 
checked the pickup screen and pipe, put it back together and tried again. Still 
no luck. Both the oil pump and cam are new, as is almost everything in this 
engine. I did not prime the pump or oil system during the build. So my question 
to The List is this: is there anything else I can try before I just pull the 
engine and check the oil pump?

TIA,

Ed Woods
------------------------

spridgets@autox.team.net


Archive: http://www.team.net/archive