My exhaust finally gave out. Wore a hole in it from scraping on the ground
all these years. It's the last thing that really needs some attention (yeah,
right). I was looking at some of the kits that they sell on-line, then
realized that they probably won't work for my setup (1275 in a RB car with
exhaust on the driver side). I called a local muffler shop that will custom
bend the pipe and install a nice performance muffler for around $325. The
question I have is do I want to go over the axle? I've seen some very sweet
setups that go over the axle and could not recall the pros and cons. I just
know that because my car sits so low, it's gonna scrape at the point under the
axle. Any pearls of wisdom? What diameter would suit my setup? I have it
bored .030 over and have a mild cam in it (Kent 286).
Edward Perez
Summerville, SC
78 Midget (1275)
http://www.flickr.com/photos/lbc_newbie/
|