I was told by Clarke Spares way back when I was restoring my Bugeye in 1999
that you could grind the top off and just drive the rest of the pin deeper in
the hole. There was supposed to be enough left of the hole above the old pin
to drive a new pin in or you might have to grind a little off the bottom of
the new pin. Can't remember if I had to grind the new pin down a little, but
it worked for me. Maybe if hacksaw/slot method does not work out...
Mike MacLean
60 Sprite
56 BN2
02 Heritage Springer
--- On Sat, 11/5/11, Dave KK7SS <kk7ss@frontier.com> wrote:
From: Dave KK7SS <kk7ss@frontier.com>
Subject: [Spridgets] Engine ID tag..
To: "spridgets_autox.team.net" <spridgets@autox.team.net>
Date: Saturday, November 5, 2011, 8:54 PM
Where can I get a new engine ID tag made, and get two of those rivets.
How do I get the old rivet bottoms out of the block?
If I drill then I widen the hole, yes?
Thanks///
--
Dave G KK7SS
Richland, WA
_______________________________________________
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|