Hi Bill,
You may find the springs have stretched, especially if the have been fitted
incorrectly at some stage. If they were fitted on the outside of the shoe
you'll find the shoes are pulled out and you get abnormal wear on the inner
side of both the shoe and drum. It may well be worth checking the braking
area on the drum to see if this is worn at an angle. If so, it is new
drums. Also check against the manual to see if the correct mounting holes
have been used for the springs.
Guy R Day
----- Original Message -----
From: <corvallis@peoplepc.com>
To: <spridgets@autox.team.net>
Sent: Sunday, October 02, 2011 12:49 AM
Subject: Re: [Spridgets] BE front brake question(s) 1960
> Well, that was it. Just let it sit there over night and it seemed better.
> Also, took the drum off of the black BE and looked at its brakes. The
> brake
> shoe return springs are happier on the inside of the shoes. All is well
> .on
> the left side. Now, about the right side. Will post more if needed. .bill
> in
> corvallis
>
>
>
> _____
>
> From: bealeguter@gmail.com [mailto:bealeguter@gmail.com] On Behalf Of
> Steven
> Guterman
> Sent: Saturday, October 01, 2011 5:38 AM
> To: corvallis@peoplepc.com
> Cc: spridgets@autox.team.net
> Subject: Re: [Spridgets] BE front brake question(s) 1960
>
>
>
> Bill,
>
> Have you tried adjusting the brakes after you put the drum in place? That
> may let them seat properly to the arch.
>
> Steve
>
> ============================================================================
> ===
>
> On Fri, Sep 30, 2011 at 8:58 PM, <corvallis@peoplepc.com> wrote:
>
> Replaced the left front wheel cylinders (and rubber brake line) on the
> 1960
> BE.
>
> The shoe springs do not appear to be holding the brake shoes snug against
> the wheel cylinders. Springs are not stretched and the lower shoe is just
> hanging there. If I adjust the brakes so there is a little tension holding
> the shoes in place, then the drum won't go on easily.
>
> And the arc of the brake material on the two shoes does not line up with
> the
> curvature of the backing plate; the leading edges of the brake material is
> really leading. Previous owner?
>
> For reference, the original VW Bug, had brake springs like this but those
> springs really snugged the shoes into place, and the brake shoe material
> lined up with the curvature of the backing plate. Ideas?? .bill in
> corvallis
> Suggested annual donation $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> <http://www.team.net/forums%0AUnsubscribe/Manage>
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/spridgets/an5.sprite@gmail.com
> _______________________________________________
>
> Donate: http://www.team.net/donate.html
> Suggested annual donation $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/spridgets/grday@btinternet.com
_______________________________________________
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|