It looks like I can just drill and tap the head to accept the new
temperature sensor, which is kind of what I was expecting.
So now I just have to decide whether to purchase a 37/64 drill bit and a 3/8
NPT tap, neither of which I am too likely to use in what's left to me of
this life time, and do the job myself, or take the darned head (fully
assembled & ceramic coated) over to my machinist and have him do the job for
about the same cost. Let's see, do my share towards keeping the economy
going or buy tools. Of course it will be difficult to find made in USA
tools. But if I have the machinist do it I won't have the pleasure of
getting oil on my hands.... or the fear that I will leave some metal bits
in the head to destroy my newly rebuilt engine.
Hal
On Tue, Jun 7, 2011 at 5:39 PM, derf <derf247@gmail.com> wrote:
> They probably used an adapter to facilitate the use of an off the
> shelf probe. You can just drill and tap the head.
> You'll have less corrosion with a brass part going into a cast iron
> part than you would steel/iron or steel/Aluminum.
> You probably want to get the probe bulb in the H2O without restricting
> the flow too much.
_______________________________________________
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|