If the engine has never been started I would prime the oil pump before cranking
it over. You could also lubricate the value mechanism and squirt some oil in
each cylinder.
Steve
------Original Message------
From: Jess Power
Sender: spridgets-bounces@autox.team.net
To: spridgets
Subject: [Spridgets] Rebuilt 1275cc
Sent: Apr 10, 2011 6:29 PM
Have a rebuilt 1275cc that turns by hand.Obvious surface rust where
the water pump goes.Was thinking of back flushing it with water before
starting it up.Anything else that should be done prior to filling it
with water,oil,and gas and cranking it up?
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe/Manage:
http://autox.team.net/mailman/options/spridgets/an5.sprite@gmail.com
Sent from my Verizon Wireless BlackBerry
_______________________________________________
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|