Hopefully you would not need to heat the hubs but if you are replacing the
bearings then replace the seal also. They are nickel dime items as compared to
the bearings and work involved in doing the replacement.
Bob Kitterer
1960 Austin Healey Sprite (Mk IV in disguise) - in storage
1966 Austin Healey Sprite Mk III (Trevor) - still in boxes - in storage
On Nov 21, 2010, at 7:55 AM, Michael Rowe wrote:
> To install rear wheel bearings, how hot do I dare make the hubs without
>burning the oil seals?
>
> Michael Rowe
> '74 Bugeyed Midget
> '60 Sprite kit
> Long Island, NY
> _______________________________________________
>
> Donate: http://www.team.net/donate.html
> Suggested annual donation $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage:
>http://autox.team.net/mailman/options/spridgets/bkitterer@mac.com
_______________________________________________
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|