> From actual measurement of two bare rear ends:
>
>REAR AXLE ASSEMBLY
>
>TYPE DIMENSION MEASUREMENT POINTS
>
>STEEL WHEEL DIFF ASSY
>Over all width* 41 3/4" (41.75") From inside of brake
>backing plate flange to inside of opposite flange
>Left Hand Brake rod 14 3/4" (14.75") From center to
>center of clevis pin holes
>Right Hand Brake Rod 26 1/4" (26.25") From center to
>center of clevis pin holes
>
>WIRE WHEEL DIFF ASSY
>Over all width* 40 3/4" (40.75") From inside
>of brake backing plate flange to inside of opposite flange
>Left Hand Brake rod 14 " (14.00") From center to
>center of clevis pin holes
>Right Hand Brake Rod 26 " (26.00") From center to
>center of clevis pin holes
>
> *Wire wheel assembly is 1" narrower than steel wheel assy
> *Wire wheel and steel wheel rear hubs are same except for stud length
Bob Spruck
MGMaven
Sharpsburg, GA
67 Midget Vintage Racer
72 Midget Street and Show
6 parts/project cars
_______________________________________________
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|