Would you check your numbers? It seems unusual that the numbers would
have 4 significant digits beyond the decimal point. All 3 of these
numbers are very small.
> Finally making progress assembling the engine. The challenge of the day is
> that the camshaft end float is .0125", specs call between .0045" and
> .0085".
> Situation is
> New oil pump.
> New camshaft (APT SPVP3BK.)
> New thrust plate.
> Seems a bit extreme to have .005" milled off the back of the front plate!
> How do I adjust?
_______________________________________________
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|