Same here. Datsun clutch and pressure plate. The pressure plate needs to be
drilled for the alignment pins on the flywheel if you have them.
Edward Perez
Snohomish, WA
78 Midget (1275)
http://www.flickr.com/photos/lbc_newbie/
________________________________
From: David Ramsey <dwramsey@att.net>
To: Michael Rowe <mdrowe@optonline.net>
Cc: spridgets@autox.team.net
Sent: Fri, February 12, 2010 7:22:49 PM
Subject: Re: [Spridgets] Rivergate 5-speed
I used a Datsun clutch.
Crash
Those of you with Rivergate conversion kits:
How did you remove the contact plate from the fingers of the clutch pressure
plate as required to use a roller-type throw-out bearing?
Michael Rowe
Aspiring engine builder
Suggested annual donation $12.75
You are subscribed as eap2140@yahoo.com
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Suggested annual donation $12.75
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|