Quaife will do them.
In a message dated 26/01/2010 02:49:22 GMT Standard Time,
dlh2001@comcast.net writes:
It would be nice if someone would offer aftermarket 1/2" longer axle
shafts in 4340 steel.
The raw material is about $90. It would need to be machined the whole
length and splined at each end.
If you know a good machinist then I think this might be the best way to
go, but I've never met anyone
who did it this way.
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Suggested annual donation $12.75
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|