Ron,
Wouldn't that 'suck', rather than just 'vent'?
Herb
On Wed, Nov 11, 2009 at 3:41 PM, Ron Soave <soavero@yahoo.com> wrote:
> --- On Wed, 11/11/09, Peter Caldwell <peter@nosimport.com> wrote:
> > How are y'all accomplishing crankcase
> > venting with a side draught Weber on a 1275?
>
> For the intake Cannon manifold, I drilled and tapped a pipe thread where
> the flat is (the spot for Mini brake booster, I think). I did not run a
> balance tube and 1&2 were always a bit lean. I'd add a balance tube if I
> were doing it again. I used a chrysler K-car PCV valve. For Maniflow intake,
> I'm not using one (successfully) but I'd weld in a cross tube with a hose
> barb to go to a PCV valve.
_______________________________________________
Support Team.Net http://www.team.net/donate.html
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|