Can't beat good-quality 3/8" hose. Check your nipples.
I believe BMW recommends it....
Herb
On Sat, Oct 10, 2009 at 12:57 PM, Jim Johnson <bmwwxman@gmail.com> wrote:
> Okay, I'm getting going on the Midget. Never having done some of this
> stuff
> before, I have a few questions which may be pretty elementary for a lot of
> you but they are things I've simply never been involved with before.
>
> I have a small compressor - a Clarke AC2000A - 2HP, 6 Gal tank which does
> 5.0 CFM at 90 PSI. Too small to drive high volume tools, but OK for
> smaller
> stuff and for painting. It came with some really flimsy 1/4 inch yellow
> air
> hose that is all coiled up. When you pull the coil out, it pinches off the
> flow. I want to replace the hose with some better stuff. I'm wondering how
> hard it would be to go up to 3/8 ID air hose. Any thoughts welcome on
> this....
>
> --
> Cheers!!
> Jim
> Only two things are infinite, the universe and human stupidity, and I am
> not
> sure about the former. - Albert Einstein
>
--
Here is an Important Message for anyone who receives this email: If you
forward this correspondence, PLEASE DELETE THE FORWARDING HISTORY, which
includes my email address! It is a courtesy to me and others who may not
wish to have their email addresses sent all over the world! Erasing the
history helps prevent Spammers from mining addresses and viruses from being
propagated! IT ALSO PROTECTS YOU.
_______________________________________________
Support Team.Net http://www.team.net/donate.html
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|