Thanks Leo,
Did not have the fittings to bleed the MC separately but did use the
mityvac to do the bleeding along with speedbleeder valves.
Bob Kitterer
1960 Austin Healey Sprite (Mk IV in disguise)
1966 Austin Healey Sprite Mk III (Trevor) - still in boxes
2000 Miata Special Edition
On Aug 17, 2009, at 3:19 PM, ldsp wrote:
> I made some fittings with tubes on them to bleed my master cylinder
> before i hooked up the brake lines to be bled. i also beld the
> brake lines using a mityvac.
>
> Leo
> ----- Original Message ----- From: "Kitterer Bob" <bkitterer@me.com>
> To: "Spridgets" <spridgets@autox.team.net>
> Sent: Monday, August 17, 2009 4:41 PM
> Subject: [Spridgets] Brakes
>
>
>> Folks,
>>
>> Am going brain dead an could use some help. Have finished
>> installing new rubber in the bugeye hydraulic system, believe that
>> all the air is out of the lines but have no break pedal pressure.
>> Anyone know of an easy way to check the master cylinder
>> independently of the rest of the system? Or other suggestions?
>>
>> Thanks
>>
>> Bob Kitterer
>>
>> 1960 Austin Healey Sprite (Mk IV in disguise)
>> 1966 Austin Healey Sprite Mk III (Trevor) - still in boxes - for sale
>> 2000 Miata Special Edition - for sale
>> _______________________________________________
>> Support Team.Net http://www.team.net/donate.html
>>
>> You are subscribed as 60bugeye@cebridge.net
>>
>> http://www.team.net/archive
>>
>> http://autox.team.net/mailman/listinfo/spridgets
_______________________________________________
Support Team.Net http://www.team.net/donate.html
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|