2-11/16"
Peter
But, I will say that if you ever need to clamp a brake/clutch hose,
the proper tool is 2 smooth bars that squeeze the hose. Failing that,
I've used 2 smooth bolts squeezed with vise grips.
====
At 12:30 PM 6/25/2009, Marc wrote:
>Thanks - One more question - whats the correct length of of the
>slave pushrod from center of the hole to the end of the rod? Of
>interest for a '73...
>
>Peter Caldwell wrote:
>>Easier and safer for the line is to fill the MC completely, stretch
>>a plastic bag over the mouth and tighten cap back on. You have now
>>"put your thumb on the straw" and fluid won't leak.... much. Then
>>install slave, open bleeder and walk away whilst imbibing a beer.
>>It'll be bled by the time you're done with your second.
>>
>>Peter C
>>=====
>>
>>At 11:44 AM 6/25/2009, Marc wrote:
>>>I want to change a slave cylinder - Can I clamp the hose to
>>>prevent losing all the fluid without damage to the hose?
>>>
>>>--
>>>
>>>Marc
>
>--
>
>Marc
>
>
>
>
>No virus found in this incoming message.
>Checked by AVG - www.avg.com
>Version: 8.5.375 / Virus Database: 270.12.91/2201 - Release Date:
>06/25/09 06:22:00
_______________________________________________
Support Team.Net http://www.team.net/donate.html
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|