I think the factory actually put a rivet in there to keep them in place.
Someone replaced them once and must have figured out how to put a screw in
there.
David
----- Original Message -----
From: "Frank" <spritenut@comcast.net>
To: "Bill L" <pythias@pacifier.com>
Cc: <spridgets@autox.team.net>
Sent: Sunday, June 21, 2009 5:41 PM
Subject: Re: [Spridgets] Windscreen side seals
> Bill L wrote:
>> Hello Spridgets,
>>
>> No one commented before, so I'll try again...
>>
>> I have a windscreen in a frame that I'm going to replace the
>> one on the car with. I have new side and bottom seals thereto.
>>
>> I've installed the bottom seal, but looking at the side seals
>> I see that there are screws holding the seals in? .. how on
>> earth did someone get screws in there? Do I go ahead and tear
>> out the old rubber and simply slide in the new seals without
>> the screws?
>> Has anyone replaced their side seals and come across this?
>>
>>
> Maybe some one added the screws, I don't recall screws but it's been
> awhile since I did the side rubbers.
> I thought they just slide out.
>
> --
> Frank Clarici
> Toms River, NJ
> My own Fleet of Sprites
_______________________________________________
Support Team.Net http://www.team.net/donate.html
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|