Good question, Frank does Michael have to cut them out before installing new
floor pans and then clean them up and reweld before adding the bolts or is
there another way to work around that while installing new pans. Also how
about sitting them in the correct place I think I read they are tricky to
have them line up correctly.
Lin
On Tue, Jun 16, 2009 at 7:07 PM, Frank <spritenut@comcast.net> wrote:
> Michael Rowe wrote:
>
>> I have been hunting through restoration pictures and can't find a
>> definitive answer.
>> Are the BE spring mount base plates supposed to be welded to the pan (as
>> mine are), or should they be bolted on. How should I handle them when
>> putting in a new floor pan?
>>
>>
>>
> Welded and bolted.
>
> --
> Frank Clarici
> Toms River, NJ
> My own Fleet of Sprites
>
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> You are subscribed as grunthaner@gmail.com
>
> http://www.team.net/archive
>
> http://autox.team.net/mailman/listinfo/spridgets
_______________________________________________
Support Team.Net http://www.team.net/donate.html
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|