I just spent two hours on my back installing a new slave cylinder (I could
not get the top mounting bolt in or a wrench on it) only to have it leak
where the metal line attaches.
The old one was installed with the bleed screw out the top and with the
rigid line out the back (opposite of the push rod).
After looking at the moss
(http://www.mossmotors.com/Shop/ViewProducts.aspx?PlateIndexID=36484) and
V.B. catalogs it looks like the bleed screw should stick out the back
(opposite of the push rod) with the rigid line going in the top - what is
correct?
Dean Swanson
'62 A.H. Sprite mkII
_______________________________________________
Support Team.Net http://www.team.net/donate.html
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|