There is very likely a thin "C" clip or circlip holding the wheel cylinder
to the backing plate. It doesn't hold the cylinder as tightly as the "E"
spring clip does, but then again I can never get the darn e clips to work.
David
----- Original Message -----
From: <lindalnhvt@nhvt.net>
To: <spridgets@autox.team.net>
Sent: Monday, September 29, 2008 4:49 PM
Subject: [Spridgets] Rear drum brakes
> Another request to the list that knows, please...
> I'm trying to replace the brake cylinder on the left rear (drums) of my 66
> Sprite. I have it all apart with shoes, springs all free. I see no
> obvious clip on the back of the old cylinder, just a very slight raised
> edge, not close to the thickness of the new spring clip. Fluid line
> already free, bleeder removed. I can make the cylinder rock slightly, but
> can't get it out. BTW, do I remember past threads about an easier method
> than the spring clip thingy to hold the new one in?
> I've had my head stuffed in the wheel well long enough!
> TIA
> Dick B.
_______________________________________________
Support Team.Net http://www.team.net/donate.html
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|