Hi John,
--- On Wed, 9/24/08, John Caffrey <jdc6@Lehigh.EDU> wrote:
> How's that new clutch working for you?
OK, but it slipped every once in a while going hard up a hill (turn 5) towards
the end of a few sessions.
> What release
> bearing are you
> using,
Stock carbon puck /slave cylinder with a Tilton spacer/guide tube ahead of the
bearing
>and how are you limiting the throw?
There's a welded nut on the footwell firewall; a long bolt with 2 nuts on it
lines up perfectly with Tilton clutch pedal. We dialed in the throw of the
pedal by lifting the rear wheels, putting it in gear, and limiting travel after
the wheels broke free from depressing the pedal. Maybe 3/4" to 1 inch pedal
throw total!
> Something I still have to decide on.
It took quite a beating this weekend. I think the slipping problem is easily
solved. The engine bay was absolutely bone dry, so the oil must have been on
the flywheel instead this time ;-))
Regards,
Ron
_______________________________________________
Support Team.Net http://www.team.net/donate.html
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|