<<remove the clamp, and make sure it is flat and true. If it is bowed or
bent,it will not hold tightly.>>
Agreed, Brad. Joe, you 'should' also open the 'gap' that the nut & bolt
uses to 'clamp'. You may very well find the bolt BENT. Just replace it.
Now, you will be working with a GOOD, functioning part.
<<What was the issue with it not starting??>>
We ALL want to know what you DID figure out????
Ed
_______________________________________________
Support Team.Net http://www.team.net/donate.html
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|