I just bought mine (short 4" one) off of the "Snap-on" truck, about $4 or so
(in 1976,probably $45 by now!)
Bill M
> Date: Mon, 14 Jul 2008 20:50:04 -0400
> From: trevor.jessie@gmail.com
> To: spridgets@autox.team.net
> Subject: Re: [Spridgets] Wrench size...
>
> Here is a picture:
> http://www.sjdiscounttools.com/rob10696.html
>
> On Mon, Jul 14, 2008 at 8:21 PM, David Lieb <dbl@chicagolandmgclub.com>
wrote:
> >> Whitworth. ...really
> >
> > But if Whitworth sizes are by the length of one flat, what is the
> > difference?
> > As Bill L noted, I have a ratcheting wrench from LBCarCo, Part number
K10696
> > that has 3/16" and 1/4" on one end and 5/16" and 3/8" on the other end. I
> > believe it was really developed for some HVAC application, but Jeff found
> > them somewhere and stocks them for $13. MUCH easier to use than the
> > non-ratcheting ones and FAR superior to trying to round off the flats
with
> > an open-end wrench.
> > David Lieb
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> You are subscribed as billmasq@hotmail.com
>
> http://www.team.net/archive
>
> http://autox.team.net/mailman/listinfo/spridgets
_________________________________________________________________
The im Talkaton. Can 30-days of conversation change the world?
http://www.imtalkathon.com/?source=EML_WLH_Talkathon_ChangeWorld
_______________________________________________
Support Team.Net http://www.team.net/donate.html
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|