I installed mine dry, and the car idles great.
On Fri, Apr 11, 2008 at 10:30 AM, <JMFarley50@aol.com> wrote:
> I just rebuilt the SUs for my 1275. When installing on the engine, do
> folks
> leave the gaskets behind the heat shield and on either side of the
> spacers
> dry, or should I use a sealant on them?
>
> If a sealant is used, what are your recommendations for type? I have a
> tube
> of Permatex "2" non-hardening Form A Gasket Sealant that says it resists
> gasoline and a tube of high temp. RTV silicone that states it is not for
> gasoline contact. Sounds like the Permatex "2" is a possibility.
> Others?
>
> Thanks for your feedback,
> John F.
>
>
>
> **************Planning your summer road trip? Check out AOL Travel Guides.
> (
> http://travel.aol.com/travel-guide/united-states?ncid=aoltrv00030000000016
> )
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> You are subscribed as tequila.brad@gmail.com
>
> http://www.team.net/archive
>
> http://autox.team.net/mailman/listinfo/spridgets
>
--
DON JULIO 1942
www.myspace.com/tequilabrad
_______________________________________________
Support Team.Net http://www.team.net/donate.html
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|