Pulled engine etc etc.
Oil pressure was 60 or so cold then down to 20 running warm and 10 idle.
Have a new pump, no prob. now that I have one that was cut down.
Question concerns old pump.
Has a lot of wear that I can see on the outside of the outer pump part where
it rubs against the housing, both sides and circumference.
For my education, what is acceptaple for tolarances?
I expect between the circular part of the pump and the case is over .010 can
get that one in but would need a wire guage to really tell.
Yep going with the new one of course but refuse to take it apart therefor the
question.
Thanks all
_______________________________________________
Edit your replies
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|