To remove the pinion nut, get a long piece of flat steel and drill two
holes that will span the holes where the drive shaft bolts go.
See this video for some good diff action, although non lbc. Pay
attention to the companion flange tool.
http://www.youtube.com/watch?v=8APYO2sZyJU
The guy in the video is setting preload in a compression washer setup.
Good stuff, it is.
Cheers,
Derf
_______________________________________________
Edit your replies
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|