Thanks Frank,
I know I had tried pumping it up a few times, especially when I was
stuck at a light that had just turned green and couldn't get it in gear,
but I don't remember if that made it any better. If it did it was only
slightly better. I'll try putting a nylock nut on the end and see if
that helps.
Robert Weeks
Bahama, NC
Frank Clarici wrote:
> Try pumping it up, if it goes into gear with a few pumps, it's air in
> the line.
> A quick fix (temp) for a short slave rod is to put a 5/16 nylock or
> round headed nut on the end of the rod. and see it that helps.
> That will give you about a 1/4" or so more throw. But make sure you
> are not overthrowing the release bearing.
> Try pumping it up first, it that doesn't work, try the nut.
|