Re: Steering wheel nut

To:	jlaird237@cox.net
Subject:	Re: Steering wheel nut
From:	Daniel1312@aol.com
Date:	Tue, 23 Jan 2007 14:09:42 EST

The original bolt was a T rated rather than an S rated.  I think you will 
find an 
AN4H-13 bolt will be ok www.aircraftspurce.co.uk

Regards

Daniel

In a message dated 23/01/07 17:26:09 GMT Standard Time, nosimport@mailbag.com 
writes:

> Jack,
>          The shaft to rack pinion connection must allow for the pinch 
> bolt to use the "deep groove" to locate the shaft.
> 
> BE SURE TO USE A NEW HARDENED BOLT FOR THIS!!!!!   (important)
> 
> Peter  C

<Prev in Thread]	Current Thread	[Next in Thread>
Steering wheel nut, Jack Laird Re: Steering wheel nut, Peter C. Re: Steering wheel nut, Daniel1312 <= Re: Steering wheel nut, John Caffrey Re: Steering wheel nut, Ron Soave Re: Steering wheel nut, Frank Clarici Re: Steering wheel nut, Jack Laird Re: Steering wheel nut, Gregory Groiss Re: Steering wheel nut, derf Re: Steering wheel nut, john.dagostino Re: Steering wheel nut, derf Re: Steering wheel nut, Billy Zoom Steering Wheel Nut, James Gruber

Previous by Date:	Re: Bugeye with trunk, Daniel1312
Next by Date:	Re: Another buyer beware special, Bill Gilroy
Previous by Thread:	Re: Steering wheel nut, Peter C.
Next by Thread:	Re: Steering wheel nut, John Caffrey
Indexes:	[Date] [Thread] [Top] [All Lists]