If you were doing an A Series motor I would suggest you get a single SU
intake and run a single throttle body type injector. The Siamese ports on
the A make things funky for injection. But, since you mentioned Strommy, I
assume you are doing a Spitfidget. There is no reason you can't make an
intake manifold from steel or stainless steel. Use a gasket as a pattern,
cut a 1/4" or 3/16" plate and ............ You get the point.
If you come up with a nice port injection system it would be easy to plug a
blower into the system and have some real fun.
Cheers,
Derf
|