Sit on it??
Larry
On Oct 3, 2006, at 09:59 AM, Jim Johnson wrote:
> I'm trying to replace the windscreen on my MKIII Midget with one I got
> from a donor parts car. I have replaced the rubber fittings with new.
> I am unable to get the two end posts far enough down into the holes in
> the car to meet with the bolts coming through from inside. It lacks
> about 1/2 inch on both sides even with the center bracket installed
> and tight. It looks to me like the new rubber (base of each end post
> and long grommet that seals from bottom of the frame to the car body)
> need to be compressed by about that 1/2 inch in order for the bolt
> holes to match up. Does anyone have any tricks for making this happen?
>
> Cheers!!
> Jim - 68 Midget in Dodge City
>
>
--
Larry B. Macy, Ph.D.
macy@bbl.med.upenn.edu
System Manager/Administrator
Neuropsychiatry Section
Department of Psychiatry
University of Pennsylvania
3400 Spruce St. - 10 Gates
Philadelphia, PA 19104
Ask a question and you're a fool for three minutes; do not ask a
question and you're a fool for the rest of your life.
--
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.
|