Hi Mike,
did you consider this system?
http://www.brits-n-pieces.com/teile_detail.php?id=6783
I can highly recommend it as recurving is a matter of turning a screw!!!
No financial interest other than I'm selling these...
Kind regards
Eric
www.brits-n-pieces.com
-----Urspr|ngliche Nachricht-----
Von: owner-spridgets@autox.team.net
[mailto:owner-spridgets@autox.team.net]Im Auftrag von Mike Rivers
Gesendet: Donnerstag, 14. September 2006 05:59
An: spridgets@autox.team.net
Betreff: Ignition systems
Hello,
I am considering upgrading my ignition system. I
would like to install an electronic setup excluding
aftermarket add-on modules (Pertronix, Allison, etc).
I found a site that dealt with this subject-
www.starchak.ca, look under Hitachi distributor
conversion under the Tech section. It uses a
distributor from mid-80's Nissan Sentras. This sounds
like a good setup, but requires to recurve the
distributor.
Has anyone had any dealings with this setup?
Mike Rivers
1961 MG Midget 1275
[demime 1.01d removed an attachment of type application/x-pkcs7-signature which
had a name of smime.p7s]
|